Jump to content
  • Fuel Pressure Requirements For Bosch VE Injection Pump

       (0 reviews)

    Mopar1973Man

    Here are the fuel pressure requirements for a 1st Generation Dodge Cummins with a Bosch VE injection pump.

    Maximum Inlet restriction ............................... 4 In Hg

    Maximum Return line Restriction ................ 20.4 In Hg

    Maximum pressure drop across fuel filter ............ 5 PSI

    Maximum pressure at the injection pump .......... 10 PSI

    Minimum pressure at the injection pump ............. 3 PSI

    Volume of fuel pumped in 30 seconds ........ 0.79 Quarts

    The maximum inlet and return line restriction is measured using a vacuum pump against the lines looking for flow restrictions. Minimum and maximum fuel pressure are measured between both idle and WOT operation looking for the performance of the fuel pump are with the specification. The measured fuel pressure should be measured near the injection pump. The volume of fuel is measured by disconnection the fuel line and disconnecting the fuel shutoff solenoid and cranking the engine for 30 seconds.

    WARNING! Don't crank the engine for more than 30 seconds or starter damage could occur. If you need to repeat the test allow the starter to cool for at least 2-3 minutes before testing again.


    User Feedback

    There are no reviews to display.


×
×
  • Create New...

Advertisements and Ad Blockers

Mopar1973Man.Com uses the income from advertisers to pay the bills on the website. Please whitelist your ad blockers for Mopar1973Man.Com this will allow advertisements to display on our pages but allows you to still block ads on the other websites you visit. 

 

image.png

I will whitelist Mopar1973Man.Com