Jump to content
  • Donation Goals

    Mopar1973Man Medical Bills

    If you want to donate to Michael Nelson medical bills. Any fund donated here will be directed toward the medical bills and getting them paid. 


    30%
    $150.00 of $500.00 Donate Now
  • Raffles

  • P0232 Fuel Shutoff Signal Voltage Too High

       (1 review)

    Mopar1973Man

    DTC P0232: FUEL SHUTOFF SIGNAL VOLTAGE TOO HIGH

    1. Ensure ignition is off. Disconnect Fuel Pump Control Module (FPCM) connector. FPCM connector is located on the end of fuel injection pump. See Fig. 38 . FPCM is incorporated into fuel injection pump and may also be referred to as the fuel injection pump when referencing to the wiring diagram.

    2. Turn ignition on with engine off. Using a voltmeter, check voltage at terminal No 5 (Light Blue/Red wire) on FPCM connector. This is the fuel shutoff signal. Voltage should be more than 9.0 volts but less than 14.5 volts. If the voltage is within specification, conditions required to set DTC are not present at this time. The test is complete. Perform TEST VER-2A. If the voltage is not within specification, it is assumed that ECM is defective and should be replaced. Before installing replacement ECM, ensure all DTCs have been repaired to prevent damaging replacement ECM. ECM is located on driver's side of the engine, just in front of fuel transfer pump and contains a 50-pin connector. After replacing ECM, perform TEST VER-2A.



    User Feedback

    Recommended Comments

    There are no comments to display.



    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest
    Add a comment...

    ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...