Jump to content

  • P0524 Oil Pressure Too Low

       (0 reviews)
    Mopar1973Man

    By Mopar1973Man

     Share

    P0524 OIL PRESSURE TOO LOW

    When Monitored and Set Condition:

    When Monitored: While the engine is running.
    Set Condition: The oil pressure detected by the ECM is less than a calibrated value.

    POSSIBLE CAUSES

    • LOW OIL LEVEL
    • (G60) SIGNAL CIRCUIT SHORT TO GROUND
    • OIL PRESSURE SWITCH
    • INTERNAL ENGINE DAMAGE

    DIAGNOSTIC PROCEDURE

    1. Check the engine oil level. Is the engine oil in the safe operating range?
      Yes --> Go To 2
      No --> Repair any condition that may cause the oil level to be above or below the safe operating range.
    2. With the DRBIII®, erase DTCs. Turn the ignition off. Disconnect the oil pressure switch harness connector. Turn the ignition on for 1 minute. Did DTC P0521 set?
      Yes --> Go To 3
      No --> Repair the (G60) signal circuit shorted to ground.
    3. Measure the engine oil pressure with a mechanical gauge. Is the oil pressure within the acceptable operating range?
      Yes --> Replace the oil pressure switch.
      No --> Repair internal engine damage.
     Share
    Go to Cummins articles

    User Feedback

    There are no reviews to display.


Rate The Author

Please take the time and give the author a 1 to a 5-star rating for the information you have gained from anywhere on the website. All forum threads, articles, etc. If a members post is good information please don't forget to tell them "Thanks" or "Like"

Rate Us On Google

Please take the time and visit our Google Review page and give us a review of our services.

Tip Jar

If Mopar1973Man.Com has helped you with quick and timely information for your repair please consider tossing a tip in the Tip Jar

×
×
  • Create New...