Search the Community
Showing results for tags 'water hammer'.
Found 2 results
-
Ok guys, bout to pull the trigger on an Airdog 100 as soon as my tax return comes in but had a few questions. First off, my Isspro ev2 fuel pressure gauge seems to be acting funny. When I get in and crank the truck in the mornings when engine is colder the gauge will go to zero for a minute and then pop up to about 10-12 at idle which is where it normally is. No rhyme or reason though I can be driving and it will drop to zero and sometimes stay there or pop back up. My set up on the gauge is I tapped into the test port of the vp44 with a banjo/snubber bolt to a grease gun hose then to my sending unit. I used teflon tape on everything but the banjo bolt to the vp44. I hope thats a good setup but if not I need to change it which might lead to my second question. When I install the Airdog do I montior the fuel pressure from the same spot like I am now or does a fuel line run to the banjo bolt I have now. If I was guessing I probably have to get a different fitting at the vp44 but not sure. -
Has anybody had issues adjusting the pressure on the airdog2/165, the instructions say 2 turns clockwise equals 15-16 psi, but my gauge says 26 psi. Trying to reduce pressure but if i go all the way counterclockwise on the airdog i only get 21 psi. Is the air dog wrong or the gauge?
