Jump to content
  • Welcome Guest To Mopar1973Man.Com

    We are a Dodge Ram Cummins Turbo Diesel forum. We are very friendly and helpful group of Dodge Ram Cummins owners. We will try to keep your truck running the best we can and provide information for diagnostics, repairs and even guide you on the best replacement parts to use. 

     

    Registration is free. Registering on the site will provide access to many more things like...
     

    • Contribute to the Forum being able to ask questions and get support for your Dodge Ram Cummins.
    • Contribute to Article Database adding your ideas and suggestions.
    • Classified Ads posted by the members. Post up your used parts and vehicles.
    • Member Garage where you can proudly display your vehicles and modifications that you have done to them.
    • Download files, documents, and Quadzilla Adrenaline tunes for your truck.
    • 911 Support Network. We've got a group of members will to aid you if your truck breaks down on the road.
    • Reduced Advertisements displayed to you.

Recommended Posts

Hello

Anyone have any issues with the heater fan inside the cab not working?  Mine died.  I replaced the resister/relay under the glove box and it still doesn't work.  I also took the blower motor out and attached 12v and it spins great.  The fuse also looks  good.

Help?

Share this post


Link to post
Share on other sites

No power to fan when tested with meter.  That's obviously when ignition is on and fan dial to max.

I checked the fuse and it appears to be fine.

I want to find a schematic to see where everything goes and if there is anything else in the line from motor back.

Share this post


Link to post
Share on other sites

Check your fuse with the volt meter just to eliminate it. I would think it is on a circuit of its own. could be wrong though. 

Share this post


Link to post
Share on other sites

Ok sounds good.

I have a Red Neck fix right now....battery in back seat, wires and a switch to battery till I figure it out.. haha

Wish I could find a service manual for my 2012 online somewhere.

Share this post


Link to post
Share on other sites

So......I took the fuse block out and it has NO corrosion underneath, ultra clean.

Turned on ignition and there is NO voltage between the two points the fuse attaches too.  hmmmm

 

Share this post


Link to post
Share on other sites

Well....

I checked the fuse and it was fine like I said, but what I did find out was it does NOT show any voltage at the pins, UNLESS you put the positive on the one pin and the NEG on the battery ground (on the battery).  Touching the two pins with + and - no voltage, now that is weird.  Sooooo, I found out the solid blue wire going to the resister and fan motor has no voltage when the ignition is on or off for sure.  So what I had to do was run a wire from the battery positive nut on the fuse block around and tape into the  blower motor.  It works this way, problem is.....you can turn the fan on without the key turned on, so if I or someone forgets......dead batteries.  I will have to see where I can get 40A safely from the fuse block so it only turns on when I turn the key on.  Any other suggestions welcome.

Cheers

Share this post


Link to post
Share on other sites

So what was the issue? I'm having the same problem. Was the wire bad or the switch? Where did you route the new wire?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



×