Jump to content
  • Welcome To Mopar1973Man.Com

    We can see you are lurking about reading the forums and article databases. We happen to be one of the most friendliest Cummins support website on the planet. Come on and register and grab a inexpensive subscription plan. With that you can unlock even more for you. Technical support either by public forum, private support ticket, and even unlock phone support by Mopar1973Man. Mopar1973Man.Com will remain FREE to read forever!

Recommended Posts

I have a 2001 24v vp44 with a quadzilla it seems my truck does not have high idle activated I would like to change that I am new to cummins ownership 

20200402_092228.jpg

Link to post
Share on other sites
  • Administrator

Quadzilla - Warm up mode has to be turned on and set to a temperature in which will be the shutdown point of the high idle. Typically its set like 140 to 160*F of coolant. Then the high idle delay is the amount of time till high idle starts. Timer will reset if the throttle is tapped or used.

 

Screenshot_20200505-064909_iQuad.jpg

 

Mopar1973Man High Idle - The switch needs to be set for 3 CYL or 6CYL mode and give the ECM time to activate the software. This requires the ECM to be flashed by a dealer or Smarty to enable the high idle software. 

 

 

WARNING: Do not use the Quadzilla high idle at the same time trying to get 3 CYL high idle. There will be a clash of softwares and this is really hard on the engine and VP44

Link to post
Share on other sites
×
×
  • Create New...