Jump to content
  • Welcome To Mopar1973Man.Com

    We can see you are lurking about reading the forums and article databases. We happen to be one of the most friendliest Cummins support website on the planet. Come on and register and grab a inexpensive subscription plan. With that you can unlock even more for you. Technical support either by public forum, private support ticket, and even unlock phone support by Mopar1973Man. Mopar1973Man.Com will remain FREE to read forever!

Recommended Posts

I can't help unless you go by distance between back of valve cover and cowl. I think if you get that distance correct then engine angle and everything else should be ok. 4 and 1/2" from cover to metal behind rubber weather strip close to 4th valve cover bolt center of valve cover. Put a jack under tranny lift it to that distance, measure what you need for steel mount you're making allowing for some sag of mount.

20200526_201842.jpg.292f28b02d26ec9b8e82894951a5ba34.jpg

Link to post
Share on other sites
×
×
  • Create New...