Jump to content
  • Welcome To Mopar1973Man.Com

    We can see you are lurking about reading the forums and article databases. We happen to be one of the most friendliest Cummins support website on the planet. Come on and register and grab a inexpensive subscription plan. With that you can unlock even more for you. Technical support either by public forum, private support ticket, and even unlock phone support by Mopar1973Man. Mopar1973Man.Com will remain FREE to read forever!

Recommended Posts

Can some one give me the torque spec for the vp44 side?  I think it's 28ft pounds on the injector side and 89 inch pounds for the injector hold down. Crows foot pretty much mandatory for putting in new injectors and getting the right torque spec?

Link to post
Share on other sites
  • Board Of Directors

Hold down 89in-lb

High pressure fuel line fittings at injectors 28ft-lb

High pressure fuel line fitting at pump 18ft-lb

  • Like 1
Link to post
Share on other sites
  • Administrator

I don't know of many that actually torque to spec for lines. I no longer even worry about it because you find that you can seal thes line with little torque at all. Just make sure the injector hold down is the LAST thing you tighten. NOT the first thing...

Link to post
Share on other sites
×
×
  • Create New...