Jump to content
  • Welcome To Mopar1973Man.Com

    We can see you lurking about Mopar1973Man.Com reading articles and reading other member's posts. Are you trying to solve a problem with your Dodge / Ram Turbo Diesel Cummins? We have lots of helpful members and staff on the Mopar1973Man.Com and are willing to give guidance on how to fix or improve your truck. You know when you see good valued information here on Mopar1973Man.Com. We are not corporate owned like many of the other websites out there. Like Cummins Forum (VerticalScope Inc.). Mopar1973Man.Com is entirely privately owned and operated since 2004. Your subscription funds goes towards server maintenance and software maintenance. We happen to be one of the most friendliest and helpful websites for Cummins Owners in the world. Come join us and register and then pick a subscription plan


Recommended Posts

Pull the headliner down and you will see the holes you need to drill from the inside out. I believe I used a 1&1/8" holesaw on mine. You will need to get measurements from a truck with factory cab lights in order to get them straight. Or I think you can buy a kit from dodge with a template but that may only be for newer trucks.

Link to post
Share on other sites

Here’s how I did it, done this a couple years ago during the winter, I didn’t use a template nor did I have another truck to measure off, you really don’t even need a tape measure either


after removing the overhead console and headliner, I used a spade it the same diameter as the factory holes that are punched in the sub roof, this is just to get a mark dead center of the hole


Then just drilled with a small pilot hole up from the bottom 


Then I moved to the top and drilled down with an 1 1/8 hole saw 


I used these factory teardrop lights off a 96 dodge they came with the factory harness too. If you are using this style you will have to move the light forward of the hole about a half to 3/4 inch to allow more room for the screw holes around the large hole


The gaskets were also in good shape, and just to make install easier and mess free and if I had to change a bulb in the future I did not use any sealant either, couple years later and no leaks


Link to post
Share on other sites
  • Create New...