Jump to content
  • Welcome To Mopar1973Man.Com

    We can see you are lurking about reading the forums and article databases. We happen to be one of the most friendliest Cummins support website on the planet. Come on and register and grab a inexpensive subscription plan. With that you can unlock even more for you. Technical support either by public forum, private support ticket, and even unlock phone support by Mopar1973Man. Mopar1973Man.Com will remain FREE to read forever!

Windshield Washer Reservoir Leak at Sensor.


Recommended Posts

  • Administrator

Might try removing the rubber grommet and then use a bit of sealant like seal-all or silicone (light amounts). Then reassemble and see if that works. If the rubber is truly gone and rotten then you might have to hit the part number books in the article section hunt down the part number for it and then do a web search for that part number and see what pops up. 

Link to post
Share on other sites

It might be the bottle itself, it can be hard to tell. I messed with mine (grommet) but didn't fix it. Changed out the bottle and fixed it. It came with both grommets.

 

 

 

 

0807201531.jpg

  • Like 1
Link to post
Share on other sites
15 minutes ago, Leaky88 said:

NIsaacs,

Where did you buy the bottle?

Thanks.

 

Leaky

 

 

I got it from Rock Auto for $15.57 (CH1288112) but I see they have raised the price, maybe a different vendor.

 

http://www.rockauto.com/?carcode=1366602&parttype=10585

 

Here is one from Parts Geek:

 

https://www.partsgeek.com/p551t66-dodge-ram-2500-washer-reservoir.html

Edited by NIsaacs
Link to post
Share on other sites
3 hours ago, Leaky88 said:

Mine leaks where barb enters tank.
Can the grommet be replaced, if so where might I find replacement.

Any feedback would be appreciated.

Thanks Leaky

 

Looks like Leaky has a leaky. Mine is leaking too. I believe from the same area. Just cant seem to get to it. My lawn mower is getting all of the attention lately. Almost done on it though.

  • Like 1
Link to post
Share on other sites

it’s all good. 

If something is not dripping from these diesels, the engine should not be turned over.

 

I have not timed the duration, but it appears to be a drip, a pause, a drip, vice drip,drip, drip.

 

 I just want the fluid level to drip below sensor so I can examine/replace the grommet.  If I pull the sensor now, it will go gush, gush, gush, and Ill go cuss, cuss, cuss.

  • Haha 2
Link to post
Share on other sites
×
×
  • Create New...