Search the Community
Showing results for tags 'diablo'.
Found 3 results
-
when i had my 03 i had a smarty,tst,and the power puck by diablo...soooo. can i run the puck with my edge juice w/att and smarty? that puck is quite the little puck.
-
I've been around this block before, Which comes first, the puck or the fooler. Here are some diagrams to explain my theories. also, I'm thinking of trying to add a smoke switch, but I seem to be getting two stories 1. the signal voltage INCREASES as boost pressure increases. 2. the signal voltage DECREASES as boost pressure increases. It would also seem that having a Boost Fooler between the "Smoke Switch" and the ECM harness would eliminate the need for a resistor inline with the switch as the fooler should keep you boost signal from getting out of spec.thoughts, theories, b!#@#*$ or complaints welcomed...I have a thick skinA correction on the diagrams: Ignore anything about a smoke switch on Diagram 2, its not in there. I copied pasted and edited the notes from a later page.I would try to make my smoke switch connections on the boost fooler as 1. It has the easiest access to its wires. 2. It is the easiest and cheapest part to replace. [ATTACH]1259[/ATTACH] ECM Wiring Theories.pdf -
Sorry, Newbie here. Unfortunately, as a farmer, I have very limited play money, I can't afford a $4-600 programmer, however I was recently able to swing a Diablo Sport Power-Puck. Everything I've read suggested that it is the best bang for the buck. As advertised, it made a definite improvement, but there is still a definite turbo lag. I know, that's the nature of the beast. I was wondering what effect a boost fooler and/or Boost elbow would have combined with the power puck. Does the Puck already do boost fooling, or would it help or hinder. Also where would the fooler go, between the MAPP sensor and the Puck, or between the Puck and the stock harness? Any help would be appreciated.
