Jump to content

  • P1285 Fuel Injection Pump Controller Always On

       (0 reviews)
    Mopar1973Man

    By Mopar1973Man

     Share

    DTC P1285: FUEL INJECTION PUMP CONTROLLER ALWAYS ON

    Monitor & Set Conditions

    Fuel Pump Control Module (FPCM) is monitored with ignition off and less than 600 RPM. DTC may set when more than 4 CAN BUS messages are received from FPCM while key is off and RPM is less than 600.

    Possible Causes

    • Fuel Injection Pump Relay Stuck On

    Testing

    Turn ignition off. Remove fuel pump relay from Power Distribution Center (PDC). PDC is located at driver's side front corner of engine compartment. Fuel injection pump relay may also be referred to as fuel relay. Note which terminals on fuel pump relay correspond with cavities in PDC. Using DVOM, measure resistance between terminals on fuel pump relay that correspond with cavities No. 30 and 87 in PDC. If resistance is 5 ohms or greater, test is complete. If resistance is less than 5 ohms, replace fuel pump relay.

     Share
    Go to Cummins articles

    User Feedback

    There are no reviews to display.


Rate The Author

Please take the time and give the author a 1 to a 5-star rating for the information you have gained from anywhere on the website. All forum threads, articles, etc. If a members post is good information please don't forget to tell them "Thanks" or "Like"

Rate Us On Google

Please take the time and visit our Google Review page and give us a review of our services.

Tip Jar

If Mopar1973Man.Com has helped you with quick and timely information for your repair please consider tossing a tip in the Tip Jar

×
×
  • Create New...