Jump to content
  • P0604 ECM Software Error

       (0 reviews)

    P0604 ECM SOFTWARE ERROR

    When Monitored and Set Condition:

    When Monitored: While the key is on.
    Set Condition: Internal ECM software error.

    POSSIBLE CAUSES

    • REFLASH ECM
    • ECM

    DIAGNOSTIC PROCEDURE

    1. Using the DRBIII®, reflash the module with latest calibration Was the flash successful?
      Yes --> Go To 2
      No --> Replace the ECM.
    2. Run the engine for one minute and shut off. With the DRBIII®, read DTCs. Did P0604 set?
      Yes --> Replace the ECM.
      No --> Test Complete.

    User Feedback

    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest

×
×
  • Create New...