Truck Exterior

Morimoto M Bi-LED Projector Headlight Retro Fit       Perks of LED vs HID retrofit No warmup time Less Electrical Draw 15,000 hour rated use AKA no burnt out bulbs Less wires No relays Simpler install plug and play with newer trucks ( no dash messages due to needing a relay setup) anti-flicker might be required. extremely bright hotspot ( on par with Mini D2S 4.0 )   this doesn't come without Con's but what

Huge Shout Out to 14Cummins over on CF for this great writeup.     Ok everyone recently I completed a projector retrofit for my old man's 2011.5. I could not find a very good detailed writeup on how to do it so i figured I would make one. This is for Quad headlamps and you will still retain stock high beams. To complete this retrofit I bought some used housings in the classifieds. That way the truck could remain operational and also I wasn't as nervous about screwing up a housing. K

So I did this almost a year ago; but since someone on the forum asked me to post it I will.  FIRST OFF: THIS IS NOT FOR THE FAINT OF HEART: I've done a lot of conversions, engine swaps, and a lot of intricate trim work on houses; and by far and away, this was one of the MOST difficult projects I have ever tackled.  THIS WILL TAKE A LONG TIME: The TRS guides lie; this will probably take you 2-3 days, even with my having paved the road.  This was, by far and away, one of my biggest com

1.Disconnect and isolate the battery negative cable. 2.Remove the four plastic push-in fasteners (1) that secure the upper radiator seal to the grille support and both fender ledges. 3.Remove the two plastic push-pin rivets (2) that secure the upper radiator seal to the radiator. 4.Remove the upper radiator seal from the vehicle.     NOTE: It is not necessary to remove the grille from the front of the vehicle to service the front lamp units. The illustration shows t

Interior Map lights: 921 Dome light: 4410 Exterior Cab Lights:194NA Reverse: 921 Cargo Lights/3rd break light: 921 2010-2012 License plate: 194 2013+ License plate: 7440 Tail lights / Brake lights: 3157K Rear Lamp Bar: 194 Side Marker Lamps Dualy: 194       Headlights Dual Headlights High/Low: H13 Turn Signal: 3157K     Quad Headlights High beams: 9005 Low beams: H11 Turn Si

Huge Thanks to Loki223 over on CumminsForum for this one.  You will need The wiring harness from Dudes Diesel Performance $95 but worth it to not hack up your trucks harness. https://dudesdieselperformance.com/i-30533376-dudes-diesel-performance-tow-mirror-light-harness-13-18-ram-1500-2500-3500.html   Alright, so i know many of you have seen the tow mirror running lights done before, and this solution is specific to the 13-18 trucks. On the old way of doing this, you must run some