Search the Community
Showing results for tags 'brake light'.
Found 4 results
-
Well seems I am the latest victim of the ABS and brake light coming on.Came on sometime yesterday while driving around. I checked for codes with my Scan Gauge and nothing. Rechecked and nothing. I used the key trick and got P0500, which made sense to me. The SG still does not see it so it wont clear it. Guess i will check the connector and then replace it if all seems well with the wires. Still surprised the SG does not see it.
-
My speedo , Tach , amp and temp gauges ,brake and air bag light all quit working at same time. Oil pressure and fuel gauge still work .
-
My speedo still works so am guessing the rear sensor is still good, not a fuse prob., so I am going to take the sensors off the front of my ,wrecked 2000 3500 with auto, parts truck for me, and try them on my truck. Does anyone fore see a problem? Thanks
-
Preempted sorry if this is in the wrong place but my truck has stumped me a little bit of history they came on about three days ago and it has no codes and it just randomly on my way home the abs and park brake light came on and the spedo bounced from actual road speed down ten to twenty mph then back up then down so on and so forth the problem isnt as noticable under thirty and its off until the truck gets on the road I have reset the computer by removing the negative cables then replaced them an hour later no luck so I removed them again and replaced the rear wheel speed sensor hooked up the cables and still no luck.the reason I put this hear is because for our trucks i can by a sensor that goes into the transmission from the parts store meaning ther is two sensor but my chrysler corporation repair manual says I only have one thought and ideas? if ther is no sensor in the tranny then its down to faulty new sensor, wiring or abs computer (most likey) but pcm could still be at fault just a FYI each time the batterys were disconected and reconected I checked for codes a total of three times and have received nothing
