Jump to content
View in the app

A better way to browse. Learn more.
Mopar1973Man.Com LLC

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

P0181 Fuel Injection Pump Failure

(0 reviews)

By Mopar1973Man

· 2,718 views

DTC P0181: FUEL INJECTION PUMP FAILURE

Monitor & Set Conditions

Fuel injection pump operation is monitored with ignition on. DTC will set if a high or low voltage is detected at the fuel temperature sensor signal circuit inside the fuel injection pump controller.

Possible Causes

  • Injection Pump - Engine Running
  • Injection Pump - Engine Off

Testing

1. Turn ignition on with engine off. Using DRBIII(R) scan tool, erase any stored engine DTCs. Start engine and allow the engine to idle for one minute. Using scan tool, read engine DTCs. If DTC P0181 does not exist, go to next step. If DTC P0181 exists, replace fuel injection pump. See appropriate REMOVAL, OVERHAUL & INSTALLATION article.

2. Turn ignition off. Turn ignition on with engine off. Using scan tool, clear engine DTCs. Check for engine DTCs with ignition on and engine off. If DTC P0181 does not exist, the test is complete. If DTC P0181 exists, replace fuel injection pump. See appropriate REMOVAL, OVERHAUL & INSTALLATION article.

    • User Feedback

    There are no reviews to display.

    Configure browser push notifications
    Chrome (Android)
    1. Tap the lock icon next to the address bar.
    2. Tap Permissions → Notifications.
    3. Adjust your preference.
    Chrome (Desktop)
    1. Click the padlock icon in the address bar.
    2. Select Site settings.
    3. Find Notifications and adjust your preference.