Jump to content

  • Hotwire Test VP44

       (0 reviews)
    Me78569

    By Me78569

     Share

    Disconnect the VP44 wiring harness connector completely. 

    Connect pin 6 on the VP44 to battery ground. 

    Connect pin 7 on the VP44 to battery positive. 



    A diagram of the sockets on the VP44 wiring harness connector is included below. The pins on the VP44 will be the reverse of this diagram (a mirror image). Make sure you know which pins are which... numbers are molded on the connector and possibly on the VP44 (I can't remember). You must insure you don't cause any short circuits or make connections to the wrong pins on the VP44. I would also strongly advise you to add a 15 amp fuse between the VP44 and battery positive. 

    Capture.JPG

    As soon as you make the last connection the VP44, it will be ON and ready to go. Attempt to start the engine in the normal manner. If everything is working properly, the engine will immediately start and idle and do nothing else. 

    • Like 1
    • Haha 1
     Share
    Go to Cummins articles

    User Feedback

    There are no reviews to display.


Rate The Author

Please take the time and give the author a 1 to a 5-star rating for the information you have gained from anywhere on the website. All forum threads, articles, etc. If a members post is good information please don't forget to tell them "Thanks" or "Like"

Rate Us On Google

Please take the time and visit our Google Review page and give us a review of our services.

Tip Jar

If Mopar1973Man.Com has helped you with quick and timely information for your repair please consider tossing a tip in the Tip Jar

×
×
  • Create New...