Jump to content
  • Mopar1973Man.Com High Idle / MPG Fooler Cubby Hole Installation 2nd Gen VP44 Cummins

       (1 review)

    Cubby Hole High Idle / MPG Fooler

    Mopar1973man.com no longer sells a specific Cubby hole mount, but we do provide the below template if you wish to make one yourself.  You can use the current PCB mounted switch with this faceplate.

    cubby2013.jpg

     

    As for installing you need to carefully pull your dash bezel from the dash and remove it. Then taking 3 screws out holding the cubby pocket in place and remove. Also remove the 4 screws holding the HVAC controls. This will give you room to routing the wires across the dash.

    fel5le.jpg

    Now mount the face to the cubby and using the supplied screws and nylon spacers.

    14t0war.jpg

    Continue to route the wires over to the bulk head.

    dg0vuh.jpg

    Then this part is bit tricky and requires patience carefully route the plug through the rubber boot of the bulkhead connector. The bulkhead connector inside can be released from it mount and might give you a few more inches of work room for a single hand.

    2v1ub1x.jpg

    Now route the connector to the proper placements. Black ECT to the front of the engine and the Grey IAT connectors to the rear of the engine. Now unplug both ECT and IAT and plug in the fooler cables.

    ECT
    140j3np.jpg

    IAT
    iqbvrt.jpg

    Then reassemble your Dash.
    658whv.jpg

    The only thing I didn't hook up yet was the LED power.

    • Like 1
    • Thanks 1

    User Feedback

    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest

    Dieselfuture

       1 of 1 member found this review helpful 1 / 1 member

    Had mine for a while now, nice added feature to the truck. :thumb1:

    • Like 1
    Link to comment

×
×
  • Create New...