Jump to content
View in the app

A better way to browse. Learn more.
Mopar1973Man.Com LLC

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

P0524 Oil Pressure Too Low

(0 reviews)

By Mopar1973Man

· 5,731 views

P0524 OIL PRESSURE TOO LOW

When Monitored and Set Condition:

When Monitored: While the engine is running.
Set Condition: The oil pressure detected by the ECM is less than a calibrated value.

POSSIBLE CAUSES

  • LOW OIL LEVEL
  • (G60) SIGNAL CIRCUIT SHORT TO GROUND
  • OIL PRESSURE SWITCH
  • INTERNAL ENGINE DAMAGE

DIAGNOSTIC PROCEDURE

  1. Check the engine oil level. Is the engine oil in the safe operating range?
    Yes --> Go To 2
    No --> Repair any condition that may cause the oil level to be above or below the safe operating range.
  2. With the DRBIII®, erase DTCs. Turn the ignition off. Disconnect the oil pressure switch harness connector. Turn the ignition on for 1 minute. Did DTC P0521 set?
    Yes --> Go To 3
    No --> Repair the (G60) signal circuit shorted to ground.
  3. Measure the engine oil pressure with a mechanical gauge. Is the oil pressure within the acceptable operating range?
    Yes --> Replace the oil pressure switch.
    No --> Repair internal engine damage.

    • User Feedback

    There are no reviews to display.

    Configure browser push notifications
    Chrome (Android)
    1. Tap the lock icon next to the address bar.
    2. Tap Permissions → Notifications.
    3. Adjust your preference.
    Chrome (Desktop)
    1. Click the padlock icon in the address bar.
    2. Select Site settings.
    3. Find Notifications and adjust your preference.