Posted February 25, 201213 yr Anyone know which wire needs 12v to control window up and same for down ? Trying to work out if it's my wiring or the solenoid/motor etc --- I am here: http://maps.google.com/maps?ll=32.807100,-80.107988
February 25, 201213 yr Author Ok relay is just on passenger side Which connection do I jump to create circuit for up and down ? Thx --- I am here: http://maps.google.com/maps?ll=32.806981,-80.107962
February 25, 201213 yr Author Ok It's not relay as passenger side works fine And it's not the wiring as even with a constant 12v it hangs .... And then u wait 10 mins and it will go up another. 6 inches etc So how do you replace the window lift motor ? Thx --- I am here: http://maps.google.com/maps?ll=32.806292,-80.107888
March 10, 201213 yr Author Did this today it's pretty easy in case anyone else needs Pull door and disconnect harness ^^^ Jump this with 12v to test motor ^^^^ Pull these two bolts for window frame and pull these four bolts for actuator motor ^^^^ Make sure windows taped up Remove window from frame by one nut each side ^^^^ Pull it all out through bottom and replace Done ;) Here's the part I used for drivers side around $75
March 15, 201213 yr Does the regulator come with a new motor? My pass side glass rocks and gets jammed in the window track. From what I found out is it is non repairable. Sorry couldnt help ya with the wiring. Everytime I checked this thread I was at work and couldnt upload the diagram.
March 15, 201213 yr Author Does the regulator come with a new motor? My pass side glass rocks and gets jammed in the window track. From what I found out is it is non repairable. Sorry couldnt help ya with the wiring. Everytime I checked this thread I was at work and couldnt upload the diagram. Hey - yeah the regulator and motor included in this part for $75. You can buy separately but as I wasn't sure what the issue was exactly - I just knew it wasn't my wiring harness as even with a constant 12v it still "hung". So basically it would go down ok - and then halfway back up it would just hang. Wait 10 mins and it would go most of way back up. Was a pain when you go through a parking place and have to wind down to get a ticket and then after you park had to sit in car for 10 min until it worked itself out. Anyway - replacement job was easier than I thought. Around 1hour. Only part that I got wrong was one of the main smaller parts of the regulator I put on back to front - the two bolts section/pic - (they arent equal in depth) so the window bumped it on way down ..... had to take back off and flip it around once I worked it out ...... all good
Anyone know which wire needs 12v to control window up and same for down ? Trying to work out if it's my wiring or the solenoid/motor etc --- I am here: http://maps.google.com/maps?ll=32.807100,-80.107988