ISX - 1997 Dodge Ram 2500 Cummins

[ISX]

1997 Dodge Ram 2500

 

 

• 12V Cummins Turbo Diesel
• P7100
• 13.5* Timing
• No AFC
• No Plate
• 5" Exhaust with Semi Muffler (see through) Exiting in Front of Back Tire
• Custom Boost Regulator (35PSI)
• BHAF
  •  
  • [*]5 Batteries (5240 CA) [*]Grid Heater Relay On/Off Switch [*]Custom Center Console [*]Front Air Dam [*]Added (Floor Mounted): Boost--Pyrometer--Water Temperature [*]Always On-Power Windows (Jumper Mod) [*]Brush Guard [*]Aluminum Diamond Plate Toolbox [*]Trailer Brake Controller
    
  •  
  • [*]Power/Remote Door Locks [*]Power Seats [*]Power Mirrors [*]Auto Dimming Rear View [*]Overhead Outdoor Temperature
    
  •  
  • [*]245/75/16 [*]Hankook Dynapro Tires (Back 2) [*]Michelin LTX M/S (Front 2) [*]Michelin LTX A/T (Spare) [*]Aluminum Wheels
    
  •  
  • [*]21MPG---70MPH [*]23MPG---65MPH [*]25MPG---60MPH [*]27MPG---55MPH
    

  Guesstimated Power

  •  
  • [*]350HP/850TQ
    

  Parts I have replaced

•  
•  
• [*]Thermostat-Due to fluctution, finally figured out it was normal.
  • [*]Clutch-Stock wouldn't hold, South Bend held the power for a while, blew up and now I got Valair [*]Clutch Hydraulics-Replaced to fix initial clutch issue, wasn't the issue but now it is new! [*]U-Joints-Old ones were grinding and popping, bearings disintegrated [*]Rear Wheel Bearing Seal-Leaking on right side, got a seal for when left decides to [*]Seal on Tailshaft of Trans-Have an issue with them spinning with the driveshaft and shearing from the steel base of the seal, packed with grease so driveshaft wouldn't grab it, so far so good. [*]Heater Core-Corroded
    

  Alright so I need to take a decent pic of my truck Give me time!
  http://www.mopar1973man.com//isx97/Truck%20Stuff/Ryan's%20Dodge/Exterior/IMG_0483.JPG
  
  Taken out, not cleaned up yet. It will come back out and be painted one of these days.
  http://www.mopar1973man.com//isx97/Truck%20Stuff/Ryan's%20Dodge/Engine%20Pull/IMG_0425.JPG
  
  http://www.mopar1973man.com//isx97/Truck%20Stuff/Ryan's%20Dodge/Engine%20Pull/IMG_0420.JPG
  
  http://www.mopar1973man.com//isx97/Truck%20Stuff/Ryan's%20Dodge/Engine%20Pull/IMG_0430.JPG
  
  http://www.mopar1973man.com//isx97/Truck%20Stuff/Ryan's%20Dodge/Under%20Hood/Other/IMG_1492.JPG
  
  http://www.mopar1973man.com//isx97/Truck%20Stuff/Ryan's%20Dodge/Under%20Hood/Other/IMG_1493.JPG
  
  
  
  

• [*] [*] [*] [*] [*] [*]
  

[*]335,000 Miles [*]NV4500 [*]Valair 400HP/900TQ 13" Clutch [*]1.25" Input Shaft [*]HD Pressure Plate [*]13" Flywheel [*]2WD---Dana 80---3.54