Jump to content
Mopar1973Man.Com LLC

  • Welcome To Mopar1973Man.Com LLC

    We are a privately owned support forum for the Dodge Ram Cummins Diesels. All information is free to read for everyone. To interact or ask questions you must have a subscription plan to enable all other features beyond reading. Please go over to the Subscription Page and pick out a plan that fits you best. At any time you wish to cancel the subscription please go back over to the Subscription Page and hit the Cancel button and your subscription will be stopped. All subscriptions are auto-renewing. 

Intake Air Temp Foolers for other vehicles?

flagmanruss

By flagmanruss
in General Conversations

 Share

Recommended Posts

flagmanruss

flagmanruss

Posted
Posted (edited)

I've seen "MPG chips" advertised which only plug into the IAT on the vehicle...  essentially an expensive resistor.  I easily built an IAT fooler for my 01.5 CTD.  Why not for other vehicles?  If IAT is so critical (getting the onboard computer to lean out the mix) why not alter the vehicle's intake from a CAI (my 97 Cirrus intake snorkel pokes through the radiator support frame.)  A simple alteration / baffle would have it sucking underhood air.  Or go to an ITA fooler harness like the Cummins. 

This is my daily driver & gets decent MPG in good weather but loses excessive miles in cold weather. 

 

I have emailed Caspers again for an extension harness to start from for an IAT Fooler...  I'd start with the same resistor as Cummins & think it would be close.       

Edited by flagmanruss
Link to comment
Share on other sites
 Share
Go to topic listing
×
×
  • Create New...