Jump to content
  • P0524 Oil Pressure Too Low

       (0 reviews)

    Mopar1973Man

    P0524 OIL PRESSURE TOO LOW

    When Monitored and Set Condition:

    When Monitored: While the engine is running.
    Set Condition: The oil pressure detected by the ECM is less than a calibrated value.

    POSSIBLE CAUSES

    • LOW OIL LEVEL
    • (G60) SIGNAL CIRCUIT SHORT TO GROUND
    • OIL PRESSURE SWITCH
    • INTERNAL ENGINE DAMAGE

    DIAGNOSTIC PROCEDURE

    1. Check the engine oil level. Is the engine oil in the safe operating range?
      Yes --> Go To 2
      No --> Repair any condition that may cause the oil level to be above or below the safe operating range.
    2. With the DRBIII®, erase DTCs. Turn the ignition off. Disconnect the oil pressure switch harness connector. Turn the ignition on for 1 minute. Did DTC P0521 set?
      Yes --> Go To 3
      No --> Repair the (G60) signal circuit shorted to ground.
    3. Measure the engine oil pressure with a mechanical gauge. Is the oil pressure within the acceptable operating range?
      Yes --> Replace the oil pressure switch.
      No --> Repair internal engine damage.

    User Feedback

    There are no reviews to display.


×
×
  • Create New...

Advertisements and Ad Blockers

Mopar1973Man.Com uses the income from advertisers to pay the bills on the website. Please whitelist your ad blockers for Mopar1973Man.Com this will allow advertisements to display on our pages but allows you to still block ads on the other websites you visit. 

 

image.png

I will whitelist Mopar1973Man.Com