Jump to content
Posted

Got a good story for you guys. Had a bad ecm that worked on the truck for a week or two, then intermittent no start. Put a loaner ecm and started right up, but had limited peddle as it was a fleet truck and derated. I used that for a few months, and then took it to a Cummins Workshop today to have it flashed back to factory settings. 
 

Now, the loaner wont fire, and my family had to drive 5 hours to get two different ones. Now, neither of those will fire also. I am completely confused as to what is going on or what the Cummins company could have did, and my truck is stuck at the Cummins shop. 
 

Thanks. 

  • Replies 1
  • Views 584
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Staff

Contact Auto Computer Specialist and tell them what's going on, they have helped a lot of people here with bad ECMs over the years.  Give them a call and see what they can do for you.  They are listed in the vender section on this web site.

 

Auto Computer Specialist

221 S State Rd 7, Plantation, Florida, 33317

Phone Number: (954) 513-8359