this spring i plan on dropping the tank out of my 02. i already have an airdog with a 1/2" draw straw but imn sick of low level slosh issues. im going to get a vulcan draw straw V. but while im at it, i wanna run 1/2" return lines too and have em dump into the canister rather than the filler neck. i was just wondering what size the banjo return fittings are? so i can put a jic fitting on the back of the head like the airdog supply. and from what ive found i need a barbed banjo fitting fo rthe return off the pump because of the pressure valve in the bolt. just dont know what size for that either.thanks

You must of installed it wrong... :shrug:I run all the way down to near empty without issues...

just driving its not bad but if you hit the brakes hard the fuel runs to the front of the tank and lift pressure drops. i dont run it below 3/8 of a tank. just havent been able to find the sizes of the fittings i need

Try going over to www.vulcanperformance.com he's got everything...

so far i found that the one on the back of the head is 12 mm. stil not sure about the one on the vp44. i think im just gonn arun 3/8 frpom the head and the pump and then T them together into 1/2 an back to the tank.