Search the Community
Showing results for tags 'axle'.
Found 3 results
-
I didn't know how to add to @smokeythedodge thread he has already made so here we go. Please move where needed if required. I figured I could post some helpful part numbers/info along for those looking to replace a (2002) Dana 80 pinion seal and/or pinion yoke. Sometimes obtaining part numbers can be annoying and just plain difficult. I replaced my seal due it starting to leak more as than it had. Started leaking then stopped for awhile and now just started again so I bit the bullet and dove in for repairs. I have a *flanged yoke* aside from @smokeythedodge non-flanged yoke in his thread. I have attached pictures of parts/part numbers and including the carnage on my seal and yoke. Spicer Flanged yoke pn# 3-4-14391-1X Orielly's Pinion seal pn# 100727 If anyone wants an addition to the write up, including how to remove seal and install etc. lemme know. Need to start contributing more here and I have a couple of items in my pocket I could definitely explain and help with.
- 6 replies
-
- 1
-
-
- dana 80
- pinion seal
- (and 5 more)
-
Ok guys, I’ve got a low hum at 60 mph. I did some digging and the rear end u joint has side to side play in the yoke of the rear end. I’m more than convinced this is my problem. The joint itself is not bad by any stretch of the imagination. I’ve tried to shim it to hold it tight, but that was a temporary fix and did not last but a few minutes. I went to town and brought home the Spicer and SKF replacements but both new u joints also wiggle side to side. What do I do now?
-
Working on my rear brakes this evening I discovered an unfortunate problem - my pass. side axle seal is done for. There's a nice nasty coating of oil on the inside of the drum, and the snout of the axle is covered in greasy black brake dust. I've never had an axle out of this truck before, but we rebuilt the diff in my brother-in-law's '05 Chevy 2500 (AAM axle) a couple months ago, so it's not exactly foreign ground for me... but that said, is there anything I need to look out for? I know I need to get a gasket for the axle plate, but what other parts (besides obviously the new seal) do I need to get?
