Hello everyone, just wanted to introduce ourselves (Auto Computer Specialist) and give a little background us and what we do.

We are based out of Florida with over 30 years of experience. We specialize in Light, Medium and Heavy Diesel Computers (ALL Generations of Cummins, Powerstroke and Duramax). We also Repair, Replace and Program all other Domestic Vehicles and Wiring Harness Repair and Rebuild. We have Programming, Repair/Rebuild and Replacement Service available (most Cummins Replacements in stock)! Our turn-around time is worst-case 5 days (but Cummins usually are about 2 to 3). We provide detailed notes at the end of our service with Errors Found, Repairs Performed, Possible Causes, DTC info (with DTC Specific Possible Causes) and more. We will also provide some Possible Vehicle Repairs needed (Please do not assume that by Repairing, Replacing and/or Programming a unit will correct all problems in the vehicle, Protocol Maintenance is required). W

We will be posting Helpful Tips and Videos and are here to answer any questions you may have, so please do not hesitate to contact us.

**ALL Subscribers of the forum will receive a 10% discount on any order purchased (just mention Mopar1973Man and provide your Member ID)! We have Military, First Responder and Senior Citizens discounts as well!

221 S State Rd 7
Plantation FL 33317
Phone: (954) 513-8359
Fax: (954) 688-2499
autocomputerspecialist@gmail.com
www.autocomputerspecialist.com

It is nice to see a vendor take the time to let potential customers know where they can get professional help when it comes to replacing very expensive electronic components.  You will probably hear from me one day when my high mileage truck needs a PCM or an ECM replaced.  I am sure it's only a matter of time.  

 

Thank you,

 

- John

@Auto Computer Specialist Can you reprogram my OEM 01 Cummins PCM that is a factory manual transmission truck and program the PCM for an automatic transmission?

Edited May 27, 20222 yr by 01_Cummins_4x4

Yes we can, we would need the PCM to make sure correct hardware is there. If not it would have to be upgraded to an Auto. Are u running automatic software in your ECM?