- Replies 21
- Views 2.9k
- Created
- Last Reply
Top Posters In This Topic
-
C Holmes 6 posts
-
Mopar1973Man 5 posts
-
dripley 4 posts
-
Me78569 2 posts
Most Popular Posts
-
Take the snorkel off and pressurize it from there. That sounds like what you are doing. You will not loose any air thru the waste gate. You are pressurizing the intake side. As long as whatever your u
-
How about error codes? There is lots of error codes that do not turn on the check engine light but defuel because of issues.
-
I've got a funny feeling there is something electronic that is defueling the system causing the lack of power. Then again not all codes will set the check engine light. As for the key trick the only y
Good day, everyone, I am looking for direction on an issue with my 02 24 v. I lent it (mistake) guy put 80 litres of gas in it. It was only run a couple hundred yards to park and pay and then no start. I had it flat decked home and with no idea of gas did a few checks and figured a vp44 failure. I did not repair but decided to wait till this summer when camping season started back up. Fast forward (a few months), I bought reman vp44 and proceeded to remove old pump. In the process I discovered two things, the gas and the fact that the pump had been changed at some point. I believe by a local dealer that is notorious for changing warranty items without customer knowledge. Anyway while putting the reman on at the dealer the mechanic (so called) crushed the key in the pump shaft. It was off by what I consider a lot but the truck worked perfect before the gas incident. I figured at this point the old pump was probably fine cause it was before the gas so why not now? Gas would not hurt it, it was not run at all. I ordered new key to match offset required by pump and re-installed. Truck fired and idles and revs perfect. No codes no other issues except no power and black smoke. I did discover waste gate stuck from sitting so I freed it up and no change. I do not think the pump is the culprit. Any ideas? Boost leak? Something like that? Any guidance on where to look and check appreciated. I have changed fuel and air filters, I have lots of fuel from lift pump (in tank) Black smoke tells me its getting fuel just not burning it. Thanks in advance.
Chris