Husband's truck was struck by lightening. We have read every forum, post, anything that might give us some help. All fuses are good, cluster plug ins checked, all grounds checked, brand new batteries, FAAS lift pump, Edge Programmer, scan tools hooked up and nothing. 

 

No Bus, it will not start, it will turn over, CCD in overhead. PCM replaced yesterday with no change. 

 

ANY help is greatly appreciated. This truck is the workhorse of our farm.

Head over to the 24V 2nd Gen articles and read up on CCD network bus. All the diagnostic info is there. It would help if you listed any error codes. Remember if there is any other failed modules will give the no bus message too.