Jump to content
View in the app

A better way to browse. Learn more.

Mopar1973Man.Com LLC

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Posted

Hey! Took my dash out to change my heater core yesterday Posted Image finished putting it in today got every thing hooked up except one wire that i cant remember where it goes, it comes out of the A pillar. Next problem, I hooked the batteries up and tried to read codes and the dash reads no bus Posted Image. any suggestions would be a big help thanks

  • Replies 4
  • Views 1.7k
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

That A-pillar wire was probably for visor light, dome light, something up there. I would just go through all the wires under the steering column again to make sure they are all connected. Make sure the negative wires are all connected too.

  • Author

That A-pillar wire was probably for visor light, dome light, something up there. I would just go through all the wires under the steering column again to make sure they are all connected. Make sure the negative wires are all connected too.

Thanks ill try that
  • Owner

There is a joint connector on the driver side up behind the dash. Joint Connector 7 is the junction for all the CCD networking on the truck so if the connector is loose or not socketed good the NO BUS will be displayed...

Posted Image

  • Author

THANKS for the the scematic been looking for one of thoes

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.