Hi All,

 

So what do you think, would this be the best Dodge Cummins to own?

 

Why?

 

Why not?

 

I have a 98.5, missed it by this much!

 

Just want your opinion,

Dave

Excellent, have you ever blow out a seal by overfilling? Probably not the same consequences as overfilling an engine huh.

So regular pipe thread for the street "L"? Teflon tape w the threads maybe too?

Thank you,

Dave

no problem on the seal part, even with the raised oil level, it still just below halfway filled.

There should be a breather on top somewhere to keep it from building pressure when hot. Any gearbox that starts to 'suddenly leak' is usually a plugged breather suspect

Now, I can't tell you if the plug thread is metric or standard Pipe Thread...

Chances are, it'll be inch. A lot of machinery these days, even though they are metric fastener

supplied, will be 'plumbed' with inch pipe fittings.

Take out the original plug and see if it will thread up into a female fitting.. I bet it is even

bigger than 1/2, possibly 3/4?

Teflon tape or even paste will be good. I hate tape! Don't tighten the new plug that will go into

top of the L too hard, you might bust off the L flush with the transmission. Good and snug will be

good.

Thanks Rancherman, all good advice, I will heed your words, very pertinent useful information.

I'll probably just take the plug to my favorite local mom& pop hardware store & find what fits. After pondering all your suggestions, you gave me a plan. I'm out of town teaching the rest of this week, can't wait to get back tinkering w my truck!

Thanks again,

Dave