Injector Comparrison

[gh0stman]

Just installed DAP injectors yesterday. They came with the copper washers, injector body O rings, crossover O rings and a 1/2"ish nut that I'm not real sure what I was supposed to do with.

Yeah I was wondering about the 1/2 bolt too. Cant fit it in to pull the crossover tube out.

[Vais01]

I normally use a thin flat blade that will get a good bite on one of the threads and very slowly pry out with steady pressure. So far so good using this practice.

I have seen some very interesting ways of pulling them including pocket knives and other edged tools. Not the smartest idea in my book.

[Vais01]

Yeah I was wondering about the 1/2 bolt too. Cant fit it in to pull the crossover tube out.

It could be the injector puller rather than using an intake bolt.

[gh0stman]

Excuse me I meant nut. But my fingers said differently.

[Vais01]

Excuse me I meant nut. But my fingers said differently.

Haha. Well in that case I'm lost as well. Can't think what a 1/2 inch or 13mm nut would be for.