wagntagn Posted November 28, 2011 Share Posted November 28, 2011 is there a kit to lift the rear 2".I did the 2" level kit ,the front seams higher than the rear now Link to comment Share on other sites More sharing options...
CUMMINSDIESELPWR Posted November 28, 2011 Share Posted November 28, 2011 taller blocks? Link to comment Share on other sites More sharing options...
thracing Posted November 28, 2011 Share Posted November 28, 2011 go too your nearist spring shop and get a couple of higher blocks for the rear Link to comment Share on other sites More sharing options...
wagntagn Posted November 28, 2011 Author Share Posted November 28, 2011 Thanks!! I check with the spring shop for higher blocks Link to comment Share on other sites More sharing options...
Rogan Posted November 29, 2011 Share Posted November 29, 2011 Just remember that the taller the block, the more fulcrum advantage the axle has on the spring packs, and the better the chance of spring-wrap under torque loads. (i.e. advancing the spring fatigue) Adding a properly made leaf to your existing pack is the best way to do it, IMHO. Link to comment Share on other sites More sharing options...
thracing Posted November 29, 2011 Share Posted November 29, 2011 good point, but most guys want the hight not the stiffer ride Link to comment Share on other sites More sharing options...
Rogan Posted November 29, 2011 Share Posted November 29, 2011 good point, but most guys want the hight not the stiffer ride ..until they wrap the driveshaft out of the t-case, then wonder WTF just happened Link to comment Share on other sites More sharing options...
wagntagn Posted December 3, 2011 Author Share Posted December 3, 2011 Somebody mentioned the best is air bags ,this way you have better control on the ride & load Link to comment Share on other sites More sharing options...
Recommended Posts