Jump to content
View in the app

A better way to browse. Learn more.

Mopar1973Man.Com LLC

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Posted

When I first hooked up my mystery switch it worked great. Now it locks the convertor for maybe half a minute then it unlocks and I have to turn the truck off before it will work normally again. Gives me p0723 code which I had before too when it worked normally. p.s. I took the switch and wiring out when the truck went to the tranny shop for the rebuild cuz I didn't want them down my throat for using it. This problem occured after I got the truck back and rewired it.

  • Replies 6
  • Views 2.6k
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

Did you forget to take out the relay and put your jumper wire back in? I did that once and it caused limp mode. Just thinking out loud.Posted from my mobile phone while not driving....

I did the same thing last time I left the country for a year and when I got back it took me awhile to figure out what the problem was.:doh:

I did the same thing as well. Put the relay back in when I took the truck to the dealer to have key fobs programmed. Did find out that if you wire in a 33 ohm resistor into the ground wire you can leave the relay in and not cause any codes or limp mode when you use the switch. I read it and tried it, worked on mine and now I don't have to worry about putting the relay back in and forgetting it again. :thumb1:

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.