Jump to content
Posted

Well after some trial and error, i looked around at some other forums and someone suggested unplugging the map but leave harness plugged into comp. I should have seen smoke and more power. Well it ran the same like i had not done anything. so i toggled through the scangauge, and it showed 22 psi boost, and if i toggled to map, showed 22 also, seems i may have a permanately defueled computer or something. It runs good and no codes but my comp feels like my EZ. Any suggestions welcome.

  • Replies 10
  • Views 2k
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Owner

Actually I can answer that... When you run only the Edge Comp the boost pressure goes MAX like you see it but the problem is the VP44 is in full retarded timing. So you got lots of fuel but no timing to gain power. Eventually it will throw a P0236 code which is boost too high too long. Best to hook up the MAP sensor so you can get your timing back. Max advancement is right 0-5 PSI and boost goes up the timing retard which follows the Autoignition Temperature Laws.

  • Author

Yes i hooked it back up. I just did it to test and see. I will call edge today, i think level 4 and 5 do not work. I dont see any difference from my EZ lol. so much for 500 bucks. You think they would incorporate a safety or a way to tell when its not working, like having the lights flash when attempting a lvl that doesnt work.

  • Author

I called Edge, and what i thought may be true, so in the box it goes, the guy i spoke with is gonna put it on his 01 like mine and check it out. I really hated taking apart my time taking nice wiring job.

Edge wants $150 to fix my Juice's fuel pressure circuit.. Nah, I'll pass.

  • Author

I will report back what they find.

- - - Updated - - -

Oh and on the tap, what more can i do if i see 12 volts with key on. And if edge says it is fine it can only mean i have a weak IP, but it runs great i can't see how. Is the wire a better tap place, the guy at edge couldn't really say what the module does with the 12 volts it sees, just that it uses that voltage to communicate with the pump. I don't want to try screwing the tap in farther could mess more stuff up.

  • Author

They found nothing, they said they tested it and it worked fine. Tested on a 2001 truck like mine, so they are sending back. I will have to look elsewhere for the fueling, im thinking that the comp just works differently on different injection pumps. All i know is i put my EZ back on, and the exhaust note was very much deeper, alot deeper, sounded good. And it seemed to pull just a lil less than the comp did lol, my truck sucks:banghead:

  • Author

Ok with new HX35W, and my returned comp, boost is 30+, and it seems to work better, time will tell.

  • Owner

Make sure all sub levels are set to 5... For example 4x1 and 5x5... If you set to main level 5 it runs like a dog till you turn up 4x5 and 5x5 and now it runs strong.