Jump to content
  • Welcome To Mopar1973Man.Com

    We can see you are lurking about reading the forums and article databases. We happen to be one of the most friendliest Cummins support website on the planet. Come on and register and grab a inexpensive subscription plan. With that you can unlock even more for you. Technical support either by public forum, private support ticket, and even unlock phone support by Mopar1973Man. Mopar1973Man.Com will remain FREE to read forever!

2000 5.9 24 valve Cummins PCM won’t let truck run


Recommended Posts

I’ve been trying to figure this out for a couple days now. I’m having troubles with truck running when pcm is plugged in. If I unplug C1 It will start.  If I unplug C3 it will start but say I have C1 plugged in and plug C3 in kills it immediately. Same if it’s other way around. Could this be due to security? 
 

Please help 

Link to post
Share on other sites

Obd2 reader if I plug everything in it will read codes because I unplugged everything but you reset them and it still won’t start and no they don’t come back. Did key trick first thing before messing with it and it said p done. 

The smaller wiring harness there on drivers side fire wall must go to something that is the culprit. 

Link to post
Share on other sites

This is a long shot but I have heard here in the past of whacked oil pressure sensors causing trouble in other sensors. Might try just unplugging it and see what happens. Just spit balling here since I dont remeber the issues folks were going thru. I do remember they had no codes for it either.

Link to post
Share on other sites

Somewhere on this forum in the last couple of years, I remember seeing the identical issue in a post. I don't remember seeing the solution but keep searching and you should be able to find it. 

Link to post
Share on other sites
×
×
  • Create New...