Is there anywhere to get the same type male and female plugs for the back-up(neutral safety) switch?

To make a inline plug-in pigtail so I dont have to cut the factory harness wires to splice in a remote aftermarket back-up light on/off switch

 

Edited January 16, 20187 yr by GSP7

Wow,

 

For some reason there is not much info on the flat connector.   (I guess they only used it a couple years.)  Chrysler didn't put info in the FSM on exactly what connector.  They used a round connector for years on the same switch.  Lots of info on that.  But not much on the newer flat one. 

 

For the male end, when you figure out the series of the female  you may be able to find the compatible male.  (it may have never been made though.) 

 

Good Luck!

 

Hag

Maybe....

 

https://www.banggood.com/Waterproof-3-Pin-Way-Wire-Connector-Terminals-For-Motorcycle-Electrical-Car-Truck-p-1044108.html?rmmds=buy&cur_warehouse=CN

 

 

http://www.dx.com/p/qook-3-pin-way-waterproof-electrical-wire-connector-plug-male-female-bullet-connector-crimp-terminals-5-pcs-497883

Edited January 17, 20187 yr by GSP7

I thought there was a electric connector expert on this website ?

 

http://www.rockauto.com/en/moreinfo.php?pk=4690626&cc=1377569&jsn=568&jsn=568&jsn=568

 

Just need a 'male' side plug

 

Same plug as Map Sensor and Crankshaft Sensor

Edited January 18, 20187 yr by GSP7

Took me a bit to remember where I started out with my plugs and stuff. Try these two places. Casper if you can shot a picture of the plugs and socket the guys there are typically pretty good about finding a mate for the photo.

 

http://www.casperselectronics.com/cart/

 

https://www.mouser.com/