Can some one give me the torque spec for the vp44 side?  I think it's 28ft pounds on the injector side and 89 inch pounds for the injector hold down. Crows foot pretty much mandatory for putting in new injectors and getting the right torque spec?

Hold down 89in-lb

High pressure fuel line fittings at injectors 28ft-lb

High pressure fuel line fitting at pump 18ft-lb

Thank you! 

I don't know of many that actually torque to spec for lines. I no longer even worry about it because you find that you can seal thes line with little torque at all. Just make sure the injector hold down is the LAST thing you tighten. NOT the first thing...

I was kinda thinking that! Thank you for letting me know! I think I'll just just try a little a first if I have to crank on it then I will just tourqe it.