Posted April 30, 201411 yr Would I have any luck painting the back half of my turbo and the turn down elbow on the back of the turbo to the exhaust pipe. Mine is pretty rusty. Does the temperature of these items typically exceed the ability of high temperature paint?
April 30, 201411 yr Well the EGT's can go up to 1400* potentially. I dont know of any type of paint that would work that hot. I know even engine block paint is usually only good up to about 550*. Plastikote does make a "HI-TEMP" paint that is supposed to be good for headers and stuff. They say it is good for up to 1300* intermittently. Not sure if that would hold up for long either. Couldnt hurt to try I suppose.
April 30, 201411 yr Owner Do some checking around and find wood stove paint. Like I've got a wood stove and its painted brown and with stands a heck of alot of temperature being the pyrometer daily would be pushed to 1,400*F for at least 5-10 minutes. As for engine paint most of that stuff would just burn off. I would suggest sandblasting the turbine housing and get as much rust off and give it a rough finish that paint could adhere to well.
May 1, 201411 yr i think the only thing I have seen is a ceramic coating that is paint-able or you can have it dipped in the color you want.
May 1, 201411 yr If you go that route, might as well send in the exhaust manifold too.. Black would be a nice color...
May 1, 201411 yr Author Can't afford to be out of service longer than for the paint to dry. Ain't gunna happen.
May 1, 201411 yr gotcha. same here! http://www.eastwood.com/review/product/list/id/4837/category/473/ rattle can and brushable eastwood company shows a couple of products supposed to be rated for up to 1200 degrees. Doubtful the exterior of the elbow or downpipe sees much more than that.
July 8, 201410 yr Do some checking around and find wood stove paint. Like I've got a wood stove and its painted brown and with stands a heck of alot of temperature being the pyrometer daily would be pushed to 1,400*F for at least 5-10 minutes. As for engine paint most of that stuff would just burn off. I would suggest sandblasting the turbine housing and get as much rust off and give it a rough finish that paint could adhere to well. I wouldn't sandblast anything unless you're going to rebuild the turbo, blasted sand gets into everything! Ka-blewy!
Would I have any luck painting the back half of my turbo and the turn down elbow on the back of the turbo to the exhaust pipe. Mine is pretty rusty. Does the temperature of these items typically exceed the ability of high temperature paint?