Search the Community
Showing results for tags 'pyrometer probe'.
Found 2 results
-
Ok guys I need some help! Just purchased pyro and tranny temp gauges to go along with my FP gauge. Got some questions: 1. Do you put the tranny sensor on the line that is on the left front corner of the tranny? 2. Is there any reason why they sent a 6' connector wire that goes from the pyro sensor to the elctrical sensor for the pyro? Looks like the wires are already long enough to connect! 3. Where is the best place to get the 12v power source for these 2 electrical boxes? I have seen a picture as to where to drill the manifold for the pyro sensor, I will look for that! Thanks for your input!Update:After looking for the picture where to put the EGT probe, I go and look at my manifold closer and to my surprise it is a 3 piece ATS manifold! Already has a internal allen head bolt for the probe! Bad news, I tried to remove it and it is welded tight in there from the heat I guess. So, still going to have to drill the manifold.
-
Ok got an egt now need to know 1 best location for probe. 2 if best location is exhaust manifold is it hard to drill and tap? From looking at the post here it seems pre trubo is best.
