Jump to content
  • Welcome To Mopar1973Man.Com LLC

    We are a privately owned support forum for the Dodge Ram Cummins Diesels. All information is free to read for everyone. To interact or ask questions you must have a subscription plan to enable all other features beyond reading. Please go over to the Subscription Page and pick out a plan that fits you best. At any time you wish to cancel the subscription please go back over to the Subscription Page and hit the Cancel button and your subscription will be stopped. All subscriptions are auto-renewing. 

For CajFlynn about Scangauge II


Recommended Posts

lol it looks better than mine....i used industrial grade velcro and stuck it to the bezel above the ash tray.... then used the ash tray to hold all the extra cable and then used another peice on the bottom to hold the ash tray closed up to the bottom of the scan gauge... doesnt look bad but not as sexy as a real bracket :thumbup2: dont laugh to hard lol its what i had on hand :lmao:

Link to comment
Share on other sites

  • Owner

That looks great. Can you make me 2 of those? How is it attached under the bezel?

Ummm... Be my guest... I all I did was get lucky on my mounting... Behind the bezel is a signal screw for the pouch below and basically bent a L bracket and drilled a hole. My problem was my hole was a bit off and required tweaking to get the SG to sit tight. You don't want to see the other side of that braket... It a road sign still with its reflective markings... :lmao2::lmao:
Link to comment
Share on other sites

ummm... Be my guest... I all i did was get lucky on my mounting... Behind the bezel is a signal screw for the pouch below and basically bent a l bracket and drilled a hole. My problem was my hole was a bit off and required tweaking to get the sg to sit tight. You don't want to see the other side of that braket... It a road sign still with its reflective markings... :lmao2::lmao:

that's sweet!!!!
Link to comment
Share on other sites

×
×
  • Create New...