I have just aquired a S06POD. i programed my 04. to software 3. drove it a few miles. not much of a differnace. not what i was expecting anyhow.

then went to sw9. now down low i see very little differance, but mid throttle it jumps and runs nice.

I'm compairing this to my older 02. i had an edge comp on that one. and lemme tell you, when you load the skinny peddle it'd set you back in the seat, it pulled hard.

this truck even on 9 i don't feel pulls all that hard. i get very little black smoke. i have not adjusted my waste gate. as i have yet to learn how (pointers welcome). 

 

before i get flamed to much, i do not have gauges as of yet. i do not know what my rail pressure is. i'm most certain my EGT's are not high as i'm not getting the balck cloud. i have not ran it hard for long distances just in case the EGT's are on the high side. 

does it seem like it's working right? or is something wrong with my truck? no codes,

 

thoughts please.

 

The CP3 needs "flow" vs. "pressure".

 

Big difference.

Not much activity there, hey!!!

 

 

http://competitiondiesel.com   Try these guys!!

You're right, this forum is not a busy one but you can always  count on specific response from the Smarty folks (i.e Brian, etc) and many times a lot of the actual smarty users chime in with info.

I think it would be a good place to try with questions specific to Smarty use.