Here it goes...first new topic! Well I finally ordered a FASS150 and a draw straw 5 yesterday from DAP! I have a 2000 2500 5speed 4x4 unfortunately with Dodge's intank pump "fix". I'm looking to tap into the wealth of knowledge here to see if anyone has any tips or tricks for the install? Past experience or things anyone may have done differently? Thanks in advance for any advice everyone!

First off thank you to everyone for all the insight and advice! I decided to tilt the bed for access to r&r the module. Everything went on and in without a hitch minus the hour or so fighting to get the numb pump out of the sending unit. Sitting at 19 idle and 16 WOT.   After a quick test drive and double checking everything was tight and leak free I headed out to the northern part of NM for my mulie hunt

Awesome to hear, 

 

Have a good hunt!

Yes it was! Still trying to catch back up.