OK guys need a little help here.  Was looking at the body tongiht and getting it lined up when we thought about not having all the all weight on the frame will shift the suspension a bit relative to the frame due to the linkage pivot points.  This would explain why some things didn't line up as expected.  So I am looking for the following measurements from someone with either a 2500 or 3500 frame/suspension set up (6bt engine and manual tranny if possible!).  Please note back where the measurement was taken from to the ground (center of bolt, top/bottom of bolt, joint between members, etc) something I can use as a solid reference.  I plan on torching the springs to get it to sit where it should (putting bags in instead on the build).  Thanks in advance!

Note where the fingers are (should be 4 measurements). 2 pivot bolts on the arm, the pivot on the pitman and the pivot at the passenger wheel

Edited May 9, 20187 yr by PilotHouse2500

Sorry for the delay. Weather here is basically rain (all last week & all next)  anyway, I hope these help

 

Passenger side

Front upper 20 1/4

Front lower 13 1/8

Rear upper 22 3/4

Rear lower 16

 

Drivers side

Front upper 20 3/8

Front lower 13 1/8

Rear upper  23 3/4

Rear lower 16

 

The rear upper difference has me stumped. I did double check. My truck pcm is set with a tire size of 31.75 inch diameter.  47re trans

 

L8tr

D

Finally got some dry weather. passenger side upper control arm, 19 1/8 at the axle and 21 3/8 at the rear.

ok thanks gang, plans this weekend to torch the springs and get the cab mounts welded in.

 

Pics to follow on the build thread.