Jump to content

Gutting cab/removing wires. 2000 Ram 2500 cummins

Posted

Vp44 guys.  Im doing alot of work on my truck, cutting weight etc...my plan is to completely gut the cab, pull everything out and leave just the column, seats, shifter, and guages...gonna use my tablet/quadzilla for tach and speedo.

My question is, Is there anything in the cab that is a "must have" to complete circuits or anything that if removed would cause the truck not to run? Besides the obvious **** like ignition wires.  Id also be open to wiring a push button start. Any info would be much appreciated.

  • Replies 21
  • Views 5.5k
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Most Popular Posts

  • TJ_00Cummins
    TJ_00Cummins

    Yes i am.  Been dwelling on it for a while to dedicate it to the track.  Finally popped the HG so now shes getting a huge makeover and lots of goodies. Sitting at 600/1200 right now without the upgrad

  • Chris O.
    Chris O.

    2nd Gen Dodge Ram Cummins 24 valve minimum computer list required: ECM,  PCM,  ABS (CAB - Controller Antilock Brake),  Electro-Mechanical Instrument Cluster (EMIC). At least one electronic c

  • 2000Ram2500
    2000Ram2500

    The CTM does dome lights as well i believe. Now they're calling them body control modules which basically means that anything you do to the "body" goes through that module. The CTM was the early versi

Featured Replies

2 minutes ago, pepsi71ocean said:

 

They are on the list of reliable builders, I'd be hard pressed to think that there's is something wrong with almost a dozen positive rebuilds down. 

 

 

 

They did what they were supposed to, I'm not complaining about it a bit. I took my chances gambling with programming a used and unknown to me ecm. 

Go to topic listing