Pulled the truck into the garage to replace some lights. When I tried to start it the WTS light was flashing and the truck would only crank and not fire. I tried pulling codes and got nothing. I disconnected the batteries for a few minutes and nothing changed. I unplugged the Quadzilla and the WTS light functioned as normal. The truck started right up but instantly idled at 1200rpm and then went into 3cyl idle mode. I checked my idle control switch and it’s in the off position. My throttle is also unresponsive(Timbo). Thanks to my low stall converter I was able to get the truck out of the garage and back into its parking spot. When I parked it the idle dropped to 900rpm and still no response from pedal. I assume I need to do an apps reset due to disconnecting the batteries. Could the quad really be the cause of all this? I plan on doing the reset tomorrow and completely unplug the quad just to see if it runs stock.

Got both turbos removed today and will be taking them in to get resealed while I figure out new drain lines. While I was in there I cleaned all the grounds and inspected the harness on the passenger side of the engine compartment. They all looked good except the one on the PCM had a little touch of green on the wire so I will most likely replace that one. I’m also unplugging and plugging all the connections as well. Would it be a good idea to smear some dielectric grease on the grounds? I did check a few on the other side before I ran out of steam. I off work this week so I will get out there again later.

22 minutes ago, Sycostang67 said:

Would it be a good idea to smear some dielectric grease on the grounds?

Yes. Anything to prevent oxidation from happening.

More good news, just got my Quad module back from testing and it’s toast. There’s $800 I don’t have. I can’t wait to see how the truck runs on stock tuning with all the other mods if I ever get this ecm issue sorted out. My S475 is being rebuilt and they at least verified it was due to the drain hose not flowing well enough. The S357 they said was fine and needed nothing. That’s still $500 for the rebuild and $200 for new drain lines plus whatever having the ecm rebuilt a second time will run me. 🫣. The last 10 trouble free years of operation are all catching up to me.