Search the Community
Showing results for tags 'problems'.
Found 3 results
-
hello ... for several days it gives me the p0222 code but it did not cause a fault that I felt driving, I did not use the truck for a week and yesterday when I started it it made like 8 injection cuts in a row and very strong and then the engine was turned off I just started it several times but he did the same and the throttle does not respond and the only code he gives is the P0222, I am very worried I don't know what it will be. thanks for your help. Orlando -
New to this forum, seems like a knowledgeable group of guys (shout out to y'all) However I'm having issues with my 2001 5 speed. She has a quadzilla adrenaline tuner, scheid diesel 100hp injectors, and an edge boost elbow. After installing the injectors she has a slight white haze coming from both the exhaust and the engine compartment. Both are very light. The exhaust gets denser when accelerating, and sometimes turns black. It seems to smell normal (not sweet like coolant, or like burnt oil). What could cause these symptoms if of concern at all? It also is is jerky/studdery at around 1200 rpm, but smoothes out at higher rpm, or harder throttle input. Also I have a stock clutch, with very low mileage on it. It seems to rattle under harder acceleration, is that just due to the clutch not liking the torque? -
hey yall need some help here. Had to replace my injectors due to multiple bad injectors (shop did return flow test). Ordered injectors from diesel care and when I installed them the truck idled fine for about 5 minutes then i pulled out of drive and gave it a little bit of gas and heard a ting sound and truck started dumping white smoke with rough idle. Got back in garage, figured injector wasnt seated properly and pulled all injectors and tubes. One of them had a clean tip so i figured that was the injector that unseated. reinstalled everything, started it up and once again dumping white smoke with rough idle and a knock. Called diesel care and they suggested caping off each fuel line at the rail and see which one stops the smoking. they think that the system wasnt primed properly and air made injector stick open. Could this be the case? should i cap rail and see or should i pull all injectors and send all back (already not happy cus injectors i ordered were backordered and they sent me 40 overs instead of the 50's like I wanted)? Thanks for any help! 03 Cummins common rail Video of truck idling: http://www.youtube.com/watch?v=AfDbbNmhbHs&feature=youtu.be
