Well I installed my new BD Diesel Injectors and the truck runs good. Install went well oiled up the o-ring on the injector tubes and injectors every thing snaped into place. But I checked my oil level this morning and it seems that the oil is now over the full mark. Is it possible that the injectors would leak a bit after the install ?

 

Thanks !

You might have nicked one of the orings or one might have been bad. That is where I would expect it to be coming from. 

VERY highly unlikely. It could be from all of the oil draining down into the pan.

I will check the oil level again when I get home this evening. 

I checked it again and it's fine now...don't know what happened lol

Slope or angle? Little nose high or tipped to the driver side will cause a high reading.