Posted December 18, 20159 yr Well guys I just replaced my heater core and my air only comes out the defrost and floor vents. Any suggestions why? I'm about fed up and about ready to send it to the dealership.
December 18, 20159 yr I haven't had one of these dash boards apart in a while but it sounds like one of your selector doors is stuck or a vacuum line is off or broken.
December 18, 20159 yr Author 3 minutes ago, Buzzinhalfdozen said: I haven't had one of these dash boards apart in a while but it sounds like one of your selector doors is stuck or a vacuum line is off or broken. Pretty much.
December 18, 20159 yr Did you reattach the selector tubes on the drivers side of the unit? Has like 5 different tubes for the selector switch. Edited December 18, 20159 yr by gassernomore
December 19, 20159 yr Author 7 hours ago, Buzzinhalfdozen said: 6 hours ago, gassernomore said: Did you reattach the selector tubes on the drivers side of the unit? Has like 5 different tubes for the selector switch. Found it. Main vacuum line broke. I replaced it and rerouted it through the driver side of the firewall after I found a diagram.
December 22, 20159 yr Author On Saturday, December 19, 2015 at 8:38 AM, Mopar1973Man said: Could you paste a link or a upload attachment for that map... There you go. Hope that helps in the future. Now I've run into the famous blend door coupling failure. Any ideas where to get another one.
December 22, 20159 yr Author On Saturday, December 19, 2015 at 8:38 AM, Mopar1973Man said: 6 hours ago, dripley said: i used this.http://www.heatertreater.net/?gclid=CLP4wJHR78kCFYEfHwodHr4HLw Thank you sir. It's ordered and on the way.
December 22, 20159 yr You are welcome. It was a good part with great instructions to install and index the door.
Well guys I just replaced my heater core and my air only comes out the defrost and floor vents. Any suggestions why? I'm about fed up and about ready to send it to the dealership.