Posted October 8, 20168 yr These wires were bare and the plastic falLing off is this mud problem Sorry picture didn't post but it's wires on vp 44 I was fixing to remove it too see if it could be re soldered and its touching and wires bare
October 16, 20168 yr Owner I'm going to guess the sensor is broke. I would pull it out and inspect it. Shouldn't wiggle at all. Might want to fill out your signature with your truck specs so we can help you better. Assuming its a early 24V with cam and crank then the crank is the signal for tach and used with the VP44 signal for fueling.
October 17, 20168 yr Author 22 hours ago, Mopar1973Man said: I'm going to guess the sensor is broke. I would pull it out and inspect it. Shouldn't wiggle at all. Might want to fill out your signature with your truck specs so we can help you better. Assuming its a early 24V with cam and crank then the crank is the signal for tach and used with the VP44 signal for fueling. I removed and retightened and it is snug not moving, reinstalled old IP, no start then it tried once but eventually I think my battery's are low so I quit removed IP again , waiting for one from from thoroughbred , my trucks 2001 Vin 7 no sensor behind starter but the one I was actually talking about is right below ecm ? Will let know how it runs after installing, ordered fuel pressure Guage, did not get aftermarket lift pump and don't plan to budgets very thin seeing I'm sinking all this money into a truck I just bought, I doubt it was crank sensor below the IP it's tight rpms have never jumped always come up when cranking, but it was a little loose , that I fixed ? Anyhow ttyl when I install new IP Edited October 17, 20168 yr by ItzReckless Will edit signature tonight at home always on mobile
October 17, 20168 yr someone correct me if I am wrong, the sensor below the ECM is the oil pressure switch. The cam sensor is behind the VP.
October 18, 20168 yr Author Well I never labeled the one below ecm just below IP, I was just assuming since how close it is to the starter
October 21, 20168 yr 34 minutes ago, ItzReckless said: New vp lmao runs good Im not surprised. Been there done that. Glad you got it working. Edited October 21, 20168 yr by Cumminz
October 22, 20168 yr Author someone get me to the best fuel line hose size for stock fitting 3/8 ?? return line atm is 5/16, installing my glowshit fuel gauge, doing my tag now guys thanks for help how do I edit signature
October 22, 20168 yr Author 4 hours ago, Mopar1973Man said: Supply is optimal at 1/2 inch. Return you can leave the stock size. could yo help me get my signature set up I set up my about me but idk
October 23, 20168 yr Owner Top of the screen click your user name then select settings. Next screen select signature. Fill it out with your truck year and info you can provide.
November 5, 20168 yr Author I removed my Edge EZ a while back I also disconnected the battery but my truck still smokes like stage 1 on the tune wtf ?
November 6, 20168 yr Owner Might be a good time to test your injectors. Might be a boost leak too. Edited November 6, 20168 yr by Mopar1973Man
November 6, 20168 yr Author 14 hours ago, Mopar1973Man said: Might be a good time to test your injectors. Might be a boost leak too. Boost leak explains it
These wires were bare and the plastic falLing off is this mud problem
Sorry picture didn't post but it's wires on vp 44 I was fixing to remove it too see if it could be re soldered and its touching and wires bare